mirror of
https://github.com/rzuasti/oott.git
synced 2026-07-08 19:21:54 +02:00
rzuastiandClaude Opus 4.8
38158a4ffc
Add an ArpScanner Default impl (30m/1m/10m, enabled) and mark the arp_scanner field with serde default, so the [arp_scanner] section can now be omitted entirely and fall back to code defaults — matching the pattern used by the SNMP scanner. Previously these three durations were mandatory and the backend would not start without them. Reconcile the documentation to the canonical 30m/1m/10m: fix the README NixOS example (was 15m/20m/30m) and options table (was 15m), and note that the section is optional in both the README and sample TOML. The NixOS module and sample TOML already used these values. Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
31 lines
1.2 KiB
Markdown
31 lines
1.2 KiB
Markdown
# OOTT ToDo list
|
|
|
|
- [x] Add linting to CLAUDE.md for both Rust and Dart
|
|
- [ ] Review and document the release process
|
|
- [ ] Add support for push notifications to the app (iOS and Android)
|
|
- [ ] Review the README.md file
|
|
|
|
## Backend
|
|
|
|
- [x] Add configuration options to enable/disable each scanner
|
|
- [ ] Implement the pushover API call directly to support HTML content and review notification text to use it
|
|
- [ ] Add "devices seen on last scan" to the ARP and SNMP scanners status
|
|
- [x] Review the recommended timings for the ARP scanner (change defaults) — SNMP defaults set to 10m/5s
|
|
|
|
## Frontend
|
|
|
|
- [ ] Can we add front-end tests?
|
|
- [ ] Break down oott_api.dart in modules
|
|
|
|
## Improve engine
|
|
|
|
Passive (low noise, no probing):
|
|
- Passive packet capture — observe any broadcast/multicast traffic; a device that never responds to ARP still generates traffic
|
|
|
|
Active (you probe the network):
|
|
- NDP (Neighbor Discovery Protocol) — IPv6 equivalent of ARP; important if the network uses IPv6
|
|
|
|
Via infrastructure:
|
|
- [x] SNMP query to router/firewall — pull the ARP table directly via SNMPv2c (no local probing); see `[snmp_scanner]` config
|
|
- Extend the SNMP scanner: SNMPv3 support, and switch MAC/forwarding table (port/VLAN) polling
|